FS/FD Series Specifications
(print this page for submittal)

Applications
KorKap device boxes and covers are available in several
configurations and may be used in coated conduit systems to
accommodate wiring devices, to serve as pull boxes for
conductors, or to allow for splices and taps in conductors.
Covers are available separately. Electrical continuity of the
conduit system is maintained across assembled joints.

Physical Properties
• 40 mil gray PVC exterior coating
• 2 mil gray urethane interior coating
• 3 trade sizes from 1/2" through 1"
• Available in Standard (KKFS) and Deep (KKFD) Styles
• Internal green grounding screw is standard
• Sealing sleeves on all conduit openings
• Flat molded PVC gasket mates with all standard covers

Standards
• UL Listed Standard 514B
• CSA Standard: C22.2 No. 18

(print this page for submittal)

APPROVAL STAMP:

General Disclaimers
1. All weights and dimensions are approximate and are subject to change without notice.

2. Robroy reserves the right to make engineering changes as needed.

3. Catalog numbers are not intended to represent specific manufacturers.

4. Unless indicated otherwise, all weights and measures are in inch-pound units.
1100 US Highway 271 South, Gilmer, TX 75644 • Phone: 903.843.6562 • Fax: 903.843.5595
Robroy Ethics Hotline