Conduit Bodies Specifications
(print this page for submittal)
Applications
KorKap conduit bodies with covers are offered in Form 8 and Form 7
styles, each with numerous configurations to provide a complete coated
conduit system. May be used to make 90° bends, for pull outlets, to
provide for taps or splices, to act as a mounting outlet for wiring devices
or lighting fixtures etc. Form 8 style fittings 1/2" – 2" have an integral
V-Seal gasket for superior corrosion protection. Electrical continuity of
the conduit system is maintained across assembled joints.
Physical Properties
• 40 mil gray PVC exterior coating
• 2 mil gray urethane internal coating
• 10 trade sizes from 1/2" through 4"
• Sealing sleeves on all conduit openings
• Form 7 style cover uses retained stainless screw and wedge clip design
• Form 8 style cover uses plastic encapsulated stainless steel screws with
retainers built into covers for trade sizes 1/2" through 2".
• Integral V-Seal gasket on Form 8 style, sizes 1/2" through 2"
Standards
• UL Listed Standard 514B
• CSA Standard: C22.2 No. 18
Note: Form 7 fittings are not available with encapsulated screws.
All cover screws are stainless steel. Form 8 fittings are shipped with
encapsulated screws.
(print this page for submittal)
