Pulling Elbows Specifications Applications
(print this page for submittal)

KorKap LBD conduit bodies are used at 90° bends in conduit runs
to allow straight pulls at bends, to serve as pull outlets for stiff
conductors, to allow for service entrance into buildings or to
allow conductor entrance into motors. Electrical continuity of the
conduit system is maintained across assembled joints.

Physical Properties
• 40 mil gray PVC exterior coating
• 2 mil gray urethane interior coating
• 10 trade sizes from 1/2" through 4"
• Sealing sleeves on all conduit openings
• Molded-in seal between body and cover
• Domed covers allow gentle bends of conductors
• Shipped with covers
• Angled covers allow straight pulling in either direction

Standards
• UL Listed Standard 514B
• CSA Standard: C22.2 No. 18

(print this page for submittal)

APPROVAL STAMP:

General Disclaimers
1. All weights and dimensions are approximate and are subject to change without notice.

2. Robroy reserves the right to make engineering changes as needed.

3. Catalog numbers are not intended to represent specific manufacturers.

4. Unless indicated otherwise, all weights and measures are in inch-pound units.
1100 US Highway 271 South, Gilmer, TX 75644 • Phone: 903.843.6562 • Fax: 903.843.5595
Robroy Ethics Hotline